uni wigsToday we are going to teach you how to create a parting in your Uniwigs Hair Toppers step by step.
To get started you need your uniwigs hair topper out of the package and a water bottle. You also need a tooth comb and a brush as well as a hair dryer. Normally there is no parting for our new hair toppers. You should keep the plastic dome insides the hair topper, which will provide more stability while you are making the parting and it won’t flop around too much.
First of all, you should choose the right spot for the parting. We recommend you to part the hair near the center of the hair topper, either just to the left of it or just to the right of it. Basically, you can part the hair anywhere you want on the top area of the topper. After you choose the parting place, you should spray the hair lightly. You don’t need to drench the hair just to get the hair slightly damp.
And then you can create the parting anywhere you prefer. You should comb the hair on both sides of the parting to make the hair start going that way you are manipulate the hair. You can even brush forward a little bit so that the hair comes down near your face so the hair can frame your face instead of going away, because you want the hair topper look as natural as possible.
Next take your hair dryer. And you should go ahead and direct the flow of air downward onto the top of that section that you are blow-drying. After you finish blow-drying, you can go ahead and try the hair topper on to see if you need to rearrange your parting. You can always change your parting by this method and technique. So it is super easy to achieve a very natural looking while wearing your UniWigs Hair Topper.
